Duration: 3 hours Total points: 200
Problem 8 — Digital electronics & interfacing (15 pts) Given a microcontroller GPIO pin with output high 3.3 V (max source 20 mA) driving an LED requiring 10 mA at 2.0 V forward voltage. a) (5 pts) Calculate the resistor value and nearest standard 5% resistor to use. b) (5 pts) If the LED must be driven at 40 mA, propose a simple transistor driver (specify transistor type, resistor calculations, and protection). c) (5 pts) Explain briefly why direct MCU driving at 40 mA is discouraged. electrical engineering fundamentals by vincent del toro pdf
Part C — Design, analysis & applications (50 pts) Problem 7 — Filter synthesis & Bode (20 pts) Design a second-order Butterworth low-pass filter with cutoff fc = 1 kHz using an active Sallen–Key topology with unity gain buffer. Use standard component values within a factor of two. a) (6 pts) Provide component values (R1, R2, C1, C2) and show normalized component selection for Butterworth (Q=0.707). b) (6 pts) Derive the transfer function H(s) and show the -3 dB cutoff condition. c) (8 pts) Sketch (or describe numerically) magnitude Bode plot points at 10 Hz, 100 Hz, 1 kHz, 10 kHz, and 100 kHz (provide gains in dB). Duration: 3 hours Total points: 200 Problem 8
Problem 4 — Resonant circuits & bandwidth (12 pts) A series RLC has R=20 Ω, L=100 μH, C chosen so resonant frequency fr = 1 MHz. a) (4 pts) Find C. b) (4 pts) Compute Q factor and bandwidth (BW). c) (4 pts) If R is halved, state qualitatively how fr, Q, and BW change. c) (5 pts) Explain briefly why direct MCU